64a65,67
> // Revision 1.37  2001/12/27 13:24:09  mohor
> // lsr[7] was not showing overrun errors.
> //
198c201
< `include "uart_defines.v"
---
> //`include "uart_defines.v"
215a219,222
> `ifdef UART_HAS_BAUDRATE_OUTPUT
> 	, baud_o
> `endif
> 
232a240,242
> `ifdef UART_HAS_BAUDRATE_OUTPUT
> output	baud_o;
> `endif
252a263,267
> `ifdef UART_HAS_BAUDRATE_OUTPUT
> assign baud_o = enable; // baud_o is actually the enable signal
> `endif
> 
> 
336c351,357
< uart_transmitter transmitter(clk, wb_rst_i, lcr, tf_push, wb_dat_i, enable, stx_pad_o, tstate, tf_count, tx_reset, lsr_mask);
---
> wire serial_out;
> 
> uart_transmitter transmitter(clk, wb_rst_i, lcr, tf_push, wb_dat_i, enable, serial_out, tstate, tf_count, tx_reset, lsr_mask);
> 
> // handle loopback
> wire serial_in = loopback ? serial_out : srx_pad_i;
> assign stx_pad_o = loopback ? 1'b1 : serial_out;
339c360
< uart_receiver receiver(clk, wb_rst_i, lcr, rf_pop, srx_pad_i, enable, 
---
> uart_receiver receiver(clk, wb_rst_i, lcr, rf_pop, serial_in, enable,